Cantilever Gates

Heavy Industrial Cantilever Gates made from thick wall tubing, hot dipped galvanising is available. These are ideal for gravel, paved or fancy stamped concrete driveways, uneven ground and curbing. We use industrial heavy duty drive motors with a number of different access systems available.

We also offer a chain wire cantilever gate with barbwire on top to match your chain wire fence. This is a very economical gate. Installed on two large posts concreted into the ground. The rolling system and drive system is all located on these posts.

We are dedicated to deliver 100% satisfaction. We offer our full services from supply only through to design and installation.

Swing Gates – High Security

Made from steel or aluminium all with a thick wall, the heavy steel gates are installed on bearing hinges and use hydraulic motors. 200/250mm square steel posts are used to swing the gates. Photo Electric Eye Beams can be installed for safety, reader card access and loop detectors.

We are dedicated to deliver 100% satisfaction. We offer our full services from supply only through to design and installation.

Sliding Gates – High Security

Any Design – Any Size. Most of our Industrial Gates are fabricated out of steel. Either pre-galvanised or hot dipped galvanised, then powdercoated to almost any colour, if required. The largest single gate we can make in one piece is 12,500mm long x 2400mm high. Photo Electric Eye Beams can be installed for safety, reader card access and loop detectors.

Aluminium Industrial Gates can also be made. We offer earthworks, concreting and block-laying, heavy duty industrial motors and access systems.

Swing Gates

Any Design, Any Size. Our gates are fabricated from aluminium using 40 x 40 RHS frame or 50 x 50 RHS frame with either 016, 019 or 25 x 25 SHS verticals. We can powdercoat to almost any colour. We can offer you a DIY kit complete with gate, hardware and motor, or we can take care of all the installation.

We are dedicated to deliver 100% satisfaction. We offer our full services from supply only through to design and installation.

Sliding Gates

Any Design – Any Size. Our standard gates are fabricated from aluminium using 100 x 50 x 3 RHS at the bottom rail with a 50 x 50 SHS frame and either 016, 019 or 25 x 25 SHS verticals. We can powdercoat to almost any colour. We can offer you a DIY kit complete with gate, hardware and motor, or we can take care of all the installation.

We are dedicated to deliver 100% satisfaction. We offer our full services from supply only through to design and installation.

Categories
Contact Us
Call Us At: (07) 3800 9449
Share with Friends